QUALIFICATIONS
- Minimum of 5-7 years of Fitting experience
- Must be DBIDs eligible
- Must pass tack test
- Technical training preferred
- Knowledge of and ability to use hand tools and instruments associated with the Fitting trade
- Must be able to work effectively with others
- Comprehend blueprints, sketches, and templates.
- Enter and move through manholes to reach and work internally confined spaces

ESSENTIAL DUTIES AND RESPONSIBILITIES
- Template creation
- Working with presses, floor shaping, forming plates, shaping from templates, marking symbols, doors, hatches and scuttles, rolls, presses and blacksmith shop
- Laying out blueprints, checking and fitting materials, tack welding of small assemblies, aluminum and steel foundations and outfitting items
- Laying out blueprints, checking and fitting materials, tack welding of various sub-assemblies peculiar to the panel line and shell area such as: decks, bulkheads, side shells.
- Installation of structural outfit items, doors, ladders, foundations
- Effective sequencing of assembly and fitting
- Correct use of heating torches in plate heat straightening and shrinkage
- Ability to use hand and power tools
- Shop and field fabrication
- Adherence to industry codes, regulations and specifications
- Comprehend blueprints, sketches, and templates
- Tack welding
- Install simple systems without templates and blueprints
- Riveted joint repairs
- Read and understand the Chemist and Competent Persons reports and determine if job sites, particularly those involving combustible material, are safe for personnel and hot work
- Will be required to wear personal protective equipment- hard hat, safety glasses, steel toe boots/shoes and, when necessary, respirator

HOURS:
- 1st and 2nd Shift Available. 1st starts at 6AM and 2nd starts at 3PM
- Could either work 8, 10 or 12 hours per shift depending on demand

PAY:
- Local pay is up to $30/hour
- Non local is up to $27.31/hour + Per Diem