NAES is looking for Traveling Wind Blade Technicans. These Technicans will travel to the Texas, Oklahoma, New Mexico, Colorado, California, Washington, Oregon, & Minnesota regions. This position pays $30/hr plus per diem and is looking for someone to start ASAP. If you have the experience below, please APPLY TODAY!!

Summary
This position requires you to apply your blade repair skills and experience in determining, performing, and the inspection of maintenance and repair requirements for assigned Wind Turbine blades.

Essential Duties & Responsibilities
Technicians are required to weigh 270 pounds or less due to fall protection equipment limitations;
In order to safely complete vision requirements, technicians must be able to discern colors;
Perform diagnosis and repair to Wind Turbines as directed by the Site Supervisor and prepare and maintain proper documentation to support the repairs, to include parts usage and time worked;
Perform quality control inspections on repairs and maintenance functions provided by maintenance or repair sub-contractors. Prepare timely and concise reports regarding inspections to insure proper steps are taken to remedy any deficiencies;
Interact closely with onsite maintenance sub-contractor's employees and provide guidance and training when applicable;
Be proactive in regards to wind turbine counter measures or enhancements that may be needed and assist in the development of such procedure's as required;
Assist with new installation and commissioning of Wind Turbines at any Diamond site location on an "as needed" basis;
Assist with cost control management of the site to include: review of sub-contractor's daily service reports which include hours worked and parts usage. Assure proper procedures are followed by sub-contractor during troubleshooting, repairs, or counter measure installations. Assure proper procedures are followed by sub-contractor to perform regular scheduled maintenance activities. Strive to keep maintenance costs low and quality high.
Comply with all Safety policies and procedures and report any violation to the Site Supervisor immediately;
Travel up to and including 100% at the various Diamond maintained facilities across the United States.
Assist the Site Supervisor in effectively maintaining parts inventory to include initiation or continuance of inventory stock and issuance system for spare parts and defective parts control and communication;
Attend training courses, seminars, or "on the job" instruction as directed by the Company;
Protect Company confidential information by not communicating, disclosing, or using for benefit of third parties and maintain the highest degree of honesty and integrity at all times.
And, perform such other duties as may be required from time to time by the company.