Duties and Responsibilities
Provide 3D-S3D Plant Designer staff augmentation support to SRNS. Primary responsibilities include engineering analysis; 3D Modeling using Hexagon’s S3D software, Piping, Equipment and HVAC modules; design development; and, generation of design output documents. Prepare, review, and approve design change forms, disposition nonconformance reports, review vendor documents and incorporate into 3D models, and resolve construction issues.
Design services shall be provided using SRNS processes and procedures. Programmatic guidance will be provided by SRNS.

Education
An associates degree in a technical discipline and at least 10 - 12 years work experience or 12
- 16 years of practical work experience.

Experience/Skills
Requires an in-depth knowledge of engineering systems, applications, calculations, materials,
construction methods, and relevant computer applications. Applies advanced principles and practices in engineering to resolve problems identified by construction organizations in a timely manner. Continued updating on new technologies and hardware in the industry is necessary.

• Candidate must demonstrate 10 years of experience as a Plant Designer, including experience with site layouts, piping layouts, electrical commodity details, HVAC duct and equipment layouts, material handling, and vendor document reviews.
• Significant experience using Hexagon’s S3D software, Piping, Equipment and HVAC modules is required. Working knowledge of National Codes and Standards for design such as ASME B31.3 and NFPA 101 is required.
• Candidate must be able to perform field walk-downs of the job site for the engineering work being performed. These walk-downs may involve construction sites with uneven surfaces and work in progress, walking for distances over a half mile, climbing ladders to access remote areas, dressing out in protective clothing and environments where a respirator is required.
• Candidate must have the ability to produce quality documents with attention to detail.

PREFERRED QUALIFICATIONS
Possession of an active DOE clearance (L or Q) within the past two (2) years is preferred.
Formal training in Computer Aided Design or 3D modeling is preferred.
Previous SRS Design Engineering or DOE facility experience is preferred.